Want the engine to live longer? Please remember these words

How long does the engine live? These six words must be kept in mind.


1. Mill: that is to grind.

This is the basis for extending the service life, whether it is a new car or the engine after overhaul, must be followed by the procedure, before the normal operation can be put into operation.


2. Net: oil clean, water clean, air clean and body clean.

Diesel fuel and gasoline is Lord of the engine, if the diesel and gasoline is not pure, can make the precision of the body wear, fit clearance increases, causing the oil, oil, oil pressure is reduced, clearance, and even cause oil plug, holding shaft tile burning and other serious fault.

If there is a lot of dust in the air, it will accelerate the wear of cylinder liner, piston and piston ring.

If the cooling water is not pure, the cooling system will be blocked, which will prevent the engine from dissipating heat, and the lubrication condition is poor and the body is badly worn.

If the body is not clean, the surface will be corroded, shorten the service life.

QQ图片20171018105457.png

3.Foot: oil feet, water and air.

When diesel, gasoline and air supply are not in time or interruption, the starting difficulty will occur, the combustion is bad, the power is reduced, and the engine cannot function normally.

If the oil supply is insufficient or discontinued, the engine will be lubricated, the body will wear out and even burn the tile.

If the cooling water shortage can make the machine overheat, power decrease, wear and increase, reduce the service life.


4. Inspection: always check the fastening part.

It is easy to loosen bolts and nuts due to the influence of vibration and load during the use of diesel engines and gasoline engines.

There are also adjustment bolts of various parts to check, so as to avoid causing loose and damaging the body accident.


5. Adjustment: the valve clearance of the diesel engine or gasoline engine, the distribution of gas phase, the oil supply in advance and the oil pressure.

These areas should be checked and adjusted in time to ensure that the engine is always in good technical state, which can save fuel and prolong service life.


6.Use: correctly use the engine.

Before driving, lubricate the lubrication parts of each bearing.

Should stay after starting the water temperature of 40 ℃ to 50 ℃ when put into operation.

It is forbidden to work with long hours or low speed.

Before stopping, remove the load and reduce the speed.

After winter parking should be water temperature dropped to 40 ℃ to 50 ℃, put a net cooling water (note for the engine of the antifreeze).

Always maintain the engine regularly and keep the machine in good condition.

Must observe, check frequently, find fault, eliminate in time.